Klarstein DELICATESSA 3 Mode D'emploi page 67

Problem Possible Cause
The glass is Rough-edged cookware,
being scratched. unsuitable, abrasive scourer or
cleaning products are used.
Failure Inspection for induction hob
• If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes, which are listed in the
following table.
Problem Possible causes
E1/E2 Abnormal supply voltage
E3 High temperature of the pan
sensor
E5 High temperature of the IGBT
temperature sensor
Note: For all other error codes not listed in the table, turn off the hob and contact
customer service.
Possible Solution
Use cookware with flat and
smooth bases. See „Choosing
the right cookware" in section
„Getting Started".
Possible Solution
Check that the power supply is
intact, that the hob is properly
connected to the power supply,
and that it is turned on.
Check that there is no liquid
in the pot or pan on the hob.
Fill with liquid and then restart
the hob.
Please restart the induction hob
after cooling down.
EN
67