First Use And Adjustments; Adjustment Of The Seatpost Using The Quick-Release Clamp - Wayscral EVERYWAY E-50 Notice D'utilisation

I.

First use and adjustments

1. Adjustment of the seatpost using the quick-release
clamp
Adjustment nut
WARNING: the quick release systems are designed to be operated by
hand. Never use tools to block or unblock the mechanism to avoid
damaging it. To adjust the clamping force, you must use the
adjustment nut (2 in the fig. above), located opposite the lever (1 in the
fig. above) rather than turning the quick-release clamp.
To lock or unlock the system, open the quick-release lever (1) and turn
the adjustment nut (2) by hand to loosen the clamp (3). To re-tighten,
manually turn the adjustment nut to tighten the clamp, then fold the
lever.
Warning: make sure you have properly tightened the mechanism
before using the bicycle. If the lever can be operated with minimal
manual pressure, it means that it is not sufficiently tightened. The
adjustment nut must therefore be tightened without the use of tools.
Seat adjustment
A. When adjusting the seat (18) to its lowest position, make sure
that it does not touch any component of the bicycle, for example
the luggage rack. Also, be careful not to exceed the
minimum seat post insertion mark. This insertion mark
should never be visible when the bicycle is in use.
Closed
50
Open
EN