Ryobi P2508 Manuel D'utilisation page 11

ADDING BAR AND CHAIN LUBRICANT
(NOT INCLUDED)
See Figure 4.
Use premium bar and chain lubricant (not includ-
ed). It is designed for chains and chain oilers, and
is formulated to perform over a wide temperature
range with no dilution required.
NOTE: Pole saw comes from the factory with no
bar and chain lubricant added. Level should also
be checked after every 20 minutes of use and
refilled as needed.
 Remove oil cap.
 Carefully pour bar and chain lubricant into the
bar lube reservoir.
 Wipe off excess lubricant.
 Check and fill the reservoir when quick view oil
indicator is below the second to last indicator
line.
 Repeat as needed.
NOTE: Do not use dirty, used or otherwise con-
taminated lubricants. Damage may occur to the
bar or chain.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use then run for one minute.
When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain and
bar sprocket.
TO INSTALL/REMOVE BATTERY PACK
See Figure 5.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
To install:
 Insert the battery pack into the product as
shown.
OPERATION
SWITCH TRIGGER
WARNING:
Make sure the latches on the battery pack snap
in place and the battery pack is fully seated
and secure in the battery port before beginning
operation. Failure to securely seat the battery
pack could cause the battery pack to fall out,
resulting in serious personal injury.
To remove:
Locate latches on side of battery pack and de-
press both sides to release the battery pack from
the pole saw.
11 — English
QUICK VIEW
OIL INDICATOR
LOCK-OUT
BUTTON
BATTERY
OIL CAP
Fig. 4
Fig. 5