Dometic FreshWell3000 Instructions De Montage page 10

Installation
Note on electrical system (see fig. c)
No. in fig. c
Description
1 Motor ventilator (inner)
2 Motor ventilator (outer)
3 Capacitor
4 Compressor
5 Temperature sensor
6 PCB
7 PCB display
8 PCB interface
9 Soft start
10 Valve
11 Resistor
• Only a qualified electrician should connect the under-bench air conditioner to
the electrical power.
• Check that the voltage specification on the type plate is the same as that of the
power supply.
• Do not lay cables which are loose or bent next to electrically conductive material
(metal).
• Install an all-pole switch with a contact opening width of at least 3 mm on the
installation side.
8
FreshWell3000
EN