Battery Pack; Storage Recommendations; Package Contents - DeWalt XR DCD732 Traduction De La Notice D'instructions Originale

2. Any shipment containing a lithium-ion battery
with an energy rating greater than 100 watt
hours (Wh). All lithium-ion batteries have the
watt hour rating marked on the pack.
Regardless of whether a shipment is considered
excepted or fully regulated, it is the shipper's
responsibility to consult the latest regulations for
packaging, labeling/marking and documentation
requirements.
Transporting batteries can possibly cause fire if the
battery terminals inadvertently come in contact with
conductive materials. When transporting batteries,
make sure that the battery terminals are protected
and well insulated from materials that could contact
them and cause a short circuit.
The information provided in this section of the
manual is provided in good faith and believed to be
accurate at the time the document was created.
However, no warranty, expressed or implied, is
given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.

Battery Pack

BATTERY TYPE
The DCD732 and DCD737 operate on 14.4 volt
battery packs.
The DCD790 and DCD795 operate on 18 volt
battery pack.
The DCB140, DCB141, DCB142, DCB143, DCB144,
DCB145, DCB180, DCB181, DCB182, DCB183,
DCB184 or DCB185 battery packs may be used.
Refer to Technical Data for more information.

Storage Recommendations

1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
2. For long storage, it is recommended to store a
fully charged battery pack in a cool, dry place
out of the charger for optimal results.
NOTE: Battery packs should not be stored
completely depleted of charge. The battery pack will
need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge D WALT battery packs only with
E
designated D WALT chargers. Charging
E
battery packs other than the designated
D WALT batteries with a D
E
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Drill/driver or 1 drill/driver/hammerdrill
1 Charger
2 Li-Ion battery packs (C2, D2, M2, P2 models)
3 Li-Ion battery packs (C3, D3, M3, P3 models)
1 Li-Ion battery pack (C1, D1, M1, P1 models)
ENGLISH
WALT
E
39