Output Indicator - Honda EM50is Manuel De L'utilisateur

Masquer les pouces Voir aussi pour EM50is:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Output and Overload Indicators
The Output indicator (green) will remain on during normal operating
conditions.
If the generator is overloaded (see page 36), or if there is a short in the
connected appliance, the Output indicator (green) will go OFF, the
overload indicator (red) will go ON and current to the connected
appliance will be shut off.
Stop the engine if the Overload indicator (red) comes on and investigate
the overload source.
NOTE:
The Overload indicator (red) also lights in the following cases:
• When the inverter is overheated; the current to the connected
appliance will be shut off. Check to see if the air intake is obstructed.
• Before connecting an appliance to the generator, check that it is in
good order, and that its electrical rating does not exceed that of the
generator. Then connect the power cord of the appliance, and start
the engine.
(FT, GT, ITT types)

OUTPUT INDICATOR

(GREEN)
NOTE:
When an electric motor is started, both the Overload indicator (red) and
the Output indicator (green) may go on simultaneously. This is normal if
the Overload indicator (red) goes off after about five (5) seconds. If the
Overload indicator (red) stays on, consult your Honda generator dealer.
38
OVERLOAD
INDICATOR (RED)
(RT, UT types)
OUTPUT INDICATOR
(GREEN)
OVERLOAD
INDICATOR (RED)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Em65is

Table des Matières