Walk Test; Tel. Setting - Elkron CR200 GPRS Notice D'installation

2. Enter the Master code (the default Master
code is 1111) and press OK. You will enter
the Programming Menu.
The Programming Mode allows you to control
the system's advanced settings, including
telephone number, device, and other settings.
Available options are:
Wa l k
T e l . S e t t i n g
G P R S
G e n . S e t t i n g s
S p c . S e t t i n g s
D e v i c e s
S M S
R e s e t
<IMPORTANT NOTE>
Device and Control Panel tamper
detection
Programming mode.

3.1. Walk Test

Please refer to User Menu – Walk Test

3.2. Tel. Setting

This menu is for you to set telephone numbers
for sending reporting, and play/record voice
messages.
T e l . N u m b e r s
A c c o u n t
R e c o r d
T e s t
Tel. Numbers
Use the function to set a new telephone
number for reporting, or change/delete an
existing telephone number.
A maximum of 6 numbers can be stored. The
reporting prority ranges from A to F, with A
being the highest priority. Each number can
store up to 20 digits
A ) 1 2 3 4 5 6 7 8 9 . V
B )
C )
D )
E )
F )
T e s t
S e t t i n g
+ / -
K e y w o r d
G S M
is disabled
N o .
M s g
r e p o r t
1. Select the telephone number you want to
edit, press OK.
2. If the slot is empty, you will be asked to enter
a new number.
If the slot already has a number stored, you
will be asked to confirm if you want to change
the number, press "OK" to confirm.
3. Enter the telephone number, press "OK" to
confirm, if you want to delete existing
telephone number, simply press "OK"
without entering anything.
< < N N O O T T E E > >
Press Up key to enter "+" mark.
4. Select the report type for this telephone
number, there are 3 choices:
under
Voice Report – The Control Panel will dial
the telephone number and play a pre-
recorded voice message according to the
event upon answer.
Telephone numbers assigned to Voice
Report will be marked with "V" at the end in
the telephone number menu.
Digital Report – The Control Panel will dial
the telephone number to report CID event
code(s).
SMS Report – The Control Panel will send a
SMS message to the telephone number to
notify the user. For SMS report, you also
need to select the event type to be reported
with this telephone number:
< N O T E >
< N O T E >
If an Account Number is not set for
SMS Report, the Control Panel will
send a SMS message in Text format
instead. Please refer to Acc. Number
setting below.
5. Select the event type (only in Digital
Report and SMS Report) to be reported
with the telephone number. When an
event type is selected, a letter will be
displayed behind the telephone number in
the Tel.Number menu. The upper cased
letter indicates SMS reporting while the
lower cased letter indicates CID reporting.
All Event – All events will be reported.
V o i c e r e p o r t
D i g i t a l R e p o r t
S M S r e p o r t
7