User Menu; Programming Mode - Elkron CR200 GPRS Notice D'installation

2. User Menu

The User menu is for you to view system
information and test system functions.
When the system is in Disarmed Mode (Alarm
off)
A l a r m
0 0 : 0 0
Enter a valid user code to access the user
menu (the default PIN code is 1234).
Press a numeric key, the display will prompt
you to enter the PIN code:
E n t e r
Enter the complete PIN code and press OK
within 30 seconds to enter User Menu. Use Up
and Down key to scroll through the menu,
press OK to select the function.
F a u l t
L o g
Wa l k
G S M
P - M o d e
Fault Display
Fault Dsp will become available only when
fault event exists in system, to view the fault
events:
1. Use Up and Down key to scroll through the
screen and view fault event:
2. Press key to leave, you will be asked
whether you want to clear fault display.
3. If you have rectified the fault, press OK to
return to Alarm Off mode, and the rectified
fault event will be removed. (unrectified fault
event cannot be removed)
If you want to keep the fault event, press
to return to Alarm Off mode, the fault event
will remain even if it has already been
rectified.
Log
The Log memorizes the last 20 system events
including:
All Alarm Events with Device ID
All Fault Warning Events
6
O f f
0 1 J a n
C o d e
. . .
D s p
T e s t
S i g n a l
All Arming And Disarming Events
The logged events are displayed in
reversed chronological order (most recent
event first).
The log is marked with a "Start" label
before the most recent entry and "End"
after the oldest entry.
To View Log:
1. Use Up and Down key to scroll through the
screen and view log, the most recent event
will be at the start
2. The first line displays the time and date of
event, the second line displays the type of
event, and the third line tells the user or
device that caused the event
Walk Test
Walk Test allows you to test the signal range
of learned in device. To test the device:
1. Press the test or learn button on the device,
refer to device user manual for detail.
2. If the Control Panel receives the signal, the
screen will display device type, attribute,
name and signal strength in RSSI 0~9 scale
accordingly.
I R Z O N E 0 1
K i t c h e n
GSM Signal
Use GSM Signal function to check current
GSM signal strength. The signal strength will
be displayed in RSSI scale from 0~9.
P-Mode
P-Mode function
Programming mode for system configuration.
Please refer to next section Programming
Mode for detail.

3. Programming Mode

To Enter Programming Mode:
1. Select P-Mode under User Menu and press
OK. The screen will display:
P - M o d e
M - C o d e
B
allows you to
E n t e r
. . . .
9
enter