Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
be ask to confirm Force Arm action..
2. Press OK to double confirm.
3. The Exit Delay timer will begin to count
down.
4. When the Exit Delay time is up, the Control
Panel will enter the arm mode you selected.
<
<
N
N
O
O
T
T
E
E
>
>
Force arming is not required with SMS
command. If the Control Panel has a
fault when you send a SMS command
to arm Panel, the Panel will enter
selected arm mode and send back a
SMS message to notify you the
system is armed with fault event
persisting.
4.4. Disarm
When the system is under Away Arm or Home
Arm mode, to disarm the system:
1. Disarm with Control Panel:
Press Disarm key on the Control Panel,
enter the PIN code, then press "OK" to
confirm.
2. Disarm with Remote Keypad:
Enter the PIN code, then press Disarm key
on the Remote Keypad.
3. Disarm with Remote Controller:
Press Disarm key on the Remote Controller.
Entry Delay
When a Door Contact or PIR sensor set to
Entry attribute is triggered, the system will
begin
an
Entry
according to Entry Time setting. You need to
disarm the system before the timer expires, or
a burglar alarm will be activated.
4.5. Tamper Protection
The Control Panel is tamper protected from
unauthorized removal from mounted surface.
When the tamper is triggered:
If the system is in Arm mode:
The Control Panel will send a SMS alarm
event "Tamper" to programmed SMS report
telephone number, or dial the Voice report
telephone
number
message upon answer. Both the internal
and external siren/bell box will be activated
16
Delay
countdown
and
play
"Burglar"
If the system is in Home/Disarm mode:
The Control Panel will not make any report
or activate alarm. The fault LED will light up
and a fault event will be registered in the
Control Panel.
4.6. Report Sequence
When an event is detected, The Control Panel
will make report according to programmed
GPRS setting and telephone number. The
panel will always report to GPRS destination
first before moving on to make Voice and/or
SMS report according to telephone number
sequence.
4.7. Alarm Activation
During an alarm, the Control Panel wil sound
the siren, and report to programmed telephone
number. The screen will display "ALARM!
ALARM!" to notify the user
Stopping the Alarm
With Control Panel:
Enter a PIN Code and press "OK".
With Remote Keypad:
Enter a PIN Code and press "Disarm" key.
The alarm will be stopped, the device that
triggered the alarm will be displayed on
screen. Use the Down button to scroll
down the alarm event, the screen will
display whether the system reported
successfully to programmed telephone
timer
number or not.
When you finish viewing the alarm event,
the system will enter Disarm mode.
Remote Controller cannot disarm the
emergency alarm triggered by itself.
Alarm Memory
If an alarm was raised without being silenced
during your absence, and the alarm reporting
has
been
continuously show "ALARM! ALARM!" to warn
the user.
When you come back and disarm the
system, the siren will sound for 3-second
to warn you that the intruder might still be
inside your house.
carried
out;
the
screen
will
Publicité
Chapitres
Table des Matières
