Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To ensure the call is successfully received
by the recipient, the recipient should
acknowledge the message by pressing
the appropriate button on his telephone
set.
If the Control Panel does not receive any
acknowledgement, the message will be
repeated for 85 seconds. If the call is not
acknowledged within 85 seconds, the
Control Panel will then consider the call
unsuccessful and dial the next phone
number in priority.
Call Acknowledgment
There are 3 ways for the call recipient to
acknowledge the call, by pressing the
button 1, 0 or 9 on his telephone set.
Acknowledge with "1"
The Control Panel will open a one-
way listen only channel for 2 minutes
for you to listen to what is happening
on the other side.
At the last 20 seconds of the 2-
minute period, the Control Panel will
sound a beep to remind the recipient.
Press 1 again to extend another 2
minutes.
When the 2-minute period expires,
the call will automatically hang up
and dial the next number.
Acknowledge with "0"
The Control Panel will hang up.
The Control Panel will continue
Alarming.
<
N
O
T
E
>
<
N
O
T
E
>
If there are more than two numbers set for
voice reporting, voice reporting will stop
and will not dial any more numbers once
two recipients acknowledges the report
with the "0" or "1" button press.
Acknowledge with "9"
The Control Panel will hang up.
The Control Panel will stop alarming
and stop dialing.
Auto Redial
When only one telephone number is
stored and that number is engaged, the
34
Control Panel will automatically redial that
number up to maximum of 5 times with an
interval of 80 sec. between dialing
attempts.
When more than one telephone numbers
are stored, the Control Panel will dial in
accordance to the set priority order. If the
number being dialed is engaged, it will try
the next number. Each number will be
tried a maximum of 5 times and the redial
interval between each number is 20 sec.
The maximum number of times the
Control Panel will retry is 15 times.
<
<
N
N
O
O
T
T
E
E
>
>
If no phone Number is programmed,
the Control Panel will not dial.
When dialing a pager number, the
Control Panel will only send the
identity code, it will not play the
message
considered to be successful.
The same pager number will be dialed
only once.
9. Appendix
9.1. Factory Reset
The Control Panel can clear all programmed
parameters by the following sequence:
1. Power down Control Panel and turn off the
battery switch
2. Apply power while holding down the
3. Release the
key when a tone is heard,
Enter Code will be displayed.
4. Enter
the
following
5. The display will show:
R e s e t
6. Press the OK key.
7. All programmed parameters are reset to
factory default setting.
<
N
O
T
E
>
<
N
O
T
E
>
On the Step 6, pressing the " " key
will cancel the reseting process and
go back to Alarm On Mode.
and
the
call
is
keys
sequence:
, OK
E e p r o m
Y / N
not
key.
Publicité
Chapitres
Table des Matières
