Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 3. Press OK.
Step 4. The Control Panel will then sound a
long beep and transmit Learning code
to all devices simultaneously. The Out
Door Bell Box should respond by
activating its siren & strobe light
momentarily, the Indoor Bell Box
should respond by 2 short beeps while
the status LED lights up for 3 seconds.
Step 5. Place these auxiliary devices out of
Learn mode.
system is completed.
<
<
N
N
O
O
T
T
E
E
>
>
If any of these devices does not
respond, make sure that the device is
in learn mode and repeat the steps
again.
After they are added in, every time
pressing a PIN code & followed by OK
key will result in the Control Panel
transmitting signal to all of them.
If no other detector or Remote
Controller has been added first, the
following message will be displayed in
Step 3:
P l e a s e
o n e
The message will be displayed for 2
sec. then the screen returns to Device
+/- menu. You are requested to add a
detector or Remote Controller first
before
trying
auxiliary devices again.
<
I
M
P
O
R
T
A
N
T
N
O
T
<
I
M
P
O
R
T
A
N
T
N
O
T
For the following options, whichever option is
selected, when the Control Panel transmits
the
signal,
all
simultaneously received the signal and all
will acted accordingly.
Siren Tamp.On, Siren Tamp.Off
The Outdoor Siren and Indoor Siren tamper
switch can be enabled and disabled remotely.
This is used especially when replacing siren
battery.
Disable the Siren tamper switch by
selecting Siren Tamp.Off and press
OK. All added sirens will temporarily
lose
their
simultanously
14
Adding them into the
a d d
d e v i c e
to
program
E
>
E
>
added
sirens
Tamper
Protection
Enable the Siren tamper switch by
selecting Siren Tamp.On and press
OK. All added sirens will be enabled
with
simultanously.
<
N
O
T
E
>
<
N
O
T
E
>
The
automatically revert to On after about
an hour if not switched back.
Confirm On, Confirm Off
Both the Outdoor Siren and the Indoor
Siren can be enabled for arming and
disarming confirmation where beeps are
emitted from the Siren to validate that the
system has been armed and disarmed.
Disable the Siren Confirmation by
selecting Confirmation Off and press
OK.
Enable the Siren Confirmation by
selecting Confirmation On and press
OK.
Entry Snd On, Entry Snd Off
The Outdoor Siren and Indoor Siren can
be enabled or disabled from sounding the
Entry Delay warning beeps.
Disable the Siren Entry Sound by
selecting Entry Snd Off and press
these
OK.
Enable the Siren Entry Sound by
selecting Entry Snd On and press OK.
Learn PSS
will
This function is used to learn in Power Switch
(PSS) only.
"LEARN PSS" function is not currently
available.
the
Tamper
Siren
tamper
disable
protection
will
Publicité
Chapitres
Table des Matières
