Vibration Massage / Deactivation; Initial Use; Installation Location - Beurer MC3800 Mode D'emploi

Note
The vibration massage functions independently of the massage programmes.
To allow this, the On/Off button must be activated and the current massage programme deactivated.

Vibration massage / deactivation

You can deactivate the vibration massage by pressing the intensity button again.
Pressing the intensity button once activates the vibration massage; pressing the same button again deactivates it.

4. Initial use

Warning!
• Keep packaging material away from children!
There is a choking hazard.
• Before using the device for the first time, read the safety notes in the Safety section.
Safety, pages 13 to 15
w
Caution!
• The massage chair could damage your flooring. Place a suitable, non-slip underlay under the massage chair.

Installation location

• Install the massage chair on a sturdy and even surface.
• Before using the device for the first time, remove all obstacles in front of and behind the massage chair so that
the back rest can be lowered and the leg rest raised freely.
Caution!
Do not use sharp or pointed tools (Stanley knife) to remove the packaging.
1.) Insert 2 x AAA batteries in the hand switch according to the markings.
2.) Lift the massage chair out of
the box using the designated
holding points. Two people are
required.
5.) Now connect the back cushion
to the seat cushion and the
back rest.
3.) Unfold the back rest
to the upright posi-
tion until the locking
mechanism audibly
engages.
6.) The massage chair
is now ready for
operation.
17
4.) Insert the plug attached to a spiral
spring into the socket provided. Then
fold the seat cushion against the back
rest.