Kenwood AT281 Manuel D'instructions page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
121160 Iss 1 AT281_AT286 multilingual:18286 Iss 2 HB750 multi
assembly and use
1 Remove high speed outlet cover before assembling
unit
.
2 Place the pulp container onto the base unit and turn
clockwise until it locks into position. When correctly
fitted the spout should be located over the pulp
container release lever.
3 Fit the filter and push firmly into position.
4 Fit the lid into the pulp container with the interlock tab
next to the arm of the base unit. Then turn clockwise
until the interlock tab on the lid fits into the groove in
the upright arm of the base unit. When correctly fitted
the markings should align
5 Place the beaker holder onto the underside of the
attachment – the arrow on the beaker holder should
be pointing upwards and aligned with the spout and
pulp container release lever.
6 Whilst holding the beaker holder in place, fit the
attachment to the mixer by placing the spout over the
corner of the high speed outlet and then turn
clockwise to lock into position.
7 Move the beaker holder towards the back of the
mixer and then fit the beaker. Swivel the holder into
position so that the beaker is located underneath the
juice outlet
.
8 Cut the food to fit the feed tube.
The attachment will not operate if it is
G
incorrectly assembled or incorrectly fitted
to the kitchen machine or if the medium
speed outlet cover is not fitted.
9 Switch to speed 3, then place the food into the feed
tube. Push the food down evenly with the pusher -
never put your fingers in the feed tube.
10 Switch off and unplug.
11 Refit the high speed outlet cover after use.
To dismantle the juicer reverse the assembly
procedure but press the pulp container release lever
in order to remove the pulp container from base unit.
Alternatively if you want to juice a large quantity of
G
fruit or vegetables and just want to empty the beaker
and pulp container carry out the following procedure:-
1 Switch off and unplug the mixer.
2 Unlock the attachment lid and lift off.
3 Lift out the filter,
4 Swivel the beaker holder to the side, lift off the beaker
and empty.
5 Press the pulp container release lever and rotate the
pulp container anti-clockwise and lift off.
6 Empty the pulp container of waste.
7 Re-assemble the unit.
.
5
A5
important
If the juicer starts to vibrate, switch off and empty the
G
pulp from the filter. (The juicer vibrates if the pulp
becomes unevenly distributed).
Maximum capacity that can be processed at one time
G
is 500g of fruit or vegetables.
Some very hard foods may make your attachment
G
slow down or stop. If this happens switch off and
unblock the filter.
Switch off and empty the pulp and juice containers
G
regularly during use.
hints
Insert soft food slowly to get the most juice.
G
G
Vitamins disappear - the sooner you drink your juice,
the more vitamins you'll get.
If you need to store the juice for a few hours put it in
G
the fridge. It will keep better if you add a few drops of
lemon juice.
Don't drink more than three 230mls (8 fl.oz.) glasses
G
of juice a day unless you're used to it.
Dilute juice for children with an equal amount of water.
G
G
Juice from dark green (broccoli, spinach etc) or dark red
(beetroot, red cabbage etc) vegetables is extremely
strong, so always dilute it.
Fruit juice is high in Fructose (fruit sugar), so people
G
with diabetes or low blood sugar should avoid
drinking too much.
care and cleaning
Always switch off and unplug before removing
G
attachment from mixer.
Dismantle the attachment fully before cleaning.
G
For easier cleaning always wash the parts immediately
G
after use.
Never let the base unit get wet.
G
Some foods, eg carrot, will discolour the plastic.
G
Rubbing with a cloth dipped in vegetable oil helps
remove discolouring.
base unit
G
Wipe with a damp cloth, then dry.
filter
Clean using a soft brush.
G
Check the filter regularly for signs of
G
damage. Do not use if the filter is damaged.
Refer to "service and customer care".
other parts
Wash, then dry. Alternatively they can be washed on
G
the top rack of your dishwasher. A short low
temperature programme is recommended.
26/2/13
08:36
Page 5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

At285At286

Table des Matières