Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. O
PERATION
This product is not designed for continual use. Make sure there are regular breaks during operation to maximize the
life of your laser. Always disconnect the COLORstrip™ Mini FX from power when not in use.
Control Panel
Operation
Menu Map
Main Level
ACt
Automatic Operation
(extra levels not
available in all
programs)
Sys
rEM
Configuration
(DMX)
DMX
Personalities and
Starting Address
Page 14 of 60
To access the control panel functions, use the four buttons located underneath the
display. When the product is on, the LED monitor on the rear panel will show the current
operating mode (standalone or DMX). The product will retain the last saved settings when
powered off.
Button
MODE
Selects an operation mode or backs out of the current menu option
UP
Scrolls up the list of options or selects a higher value
DOWN
Scrolls down the list of options or selects a lower value
ENTER
Activates a menu option or a selected value
Programming Levels
A000—A036
F000—F100
P000—P100
L000—L006
C000—C100
S000—S100
r001—r016
Ch-4
SdAd
Ch-7
SAAd
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a DMX starting address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The COLORstrip™ Mini FX uses up to 7 DMX channels in its 7-channel DMX personality,
which defines the highest configurable address to 506.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1.
Press MODE repeatedly until Sys shows on the display.
2.
Press ENTER and SdAd or SAAd shows on the display.
3.
Use the UP or DOWN to navigate to the SdAd setting.
4.
Press ENTER and Ch-4 (4-channel personality) or Ch-7 (7-channel personality)
shows on the display.
5.
Use UP or DOWN to select the desired DMX personality.
6.
Press ENTER.
7.
Use UP or DOWN to select the desired starting address.
8.
Press ENTER.
Function
Description
Flash speed (slow to fast)
Run speed (slow to fast)
Laser
Blue (only available in A034)
Laser strobe speed
Laser pattern
Sets DMX personality and
P 1—P512
starting address
Sets slave address
Remote control
COLORstrip™ Mini FX User Manual
Publicité
Table des Matières
