Waterpas Zetten - La Cornue 599 Serie Notice D'installation

2
2
1
1
Zet de apparatuur waterpas met behulp van de pootjes en de achter-
ste wieltjes aan de onderkant van de apparatuur.
Operate as follows:
After removing the bottom plinth or grille (it is kept in position by
magnets), adjust the height of the levelling feet
mm (0.6 in) open spanner.
Then adjust the height of the rear wheels by turning the front
adjusting bolts clockwise or anticlockwise as it may be required.
2
Remount the bottom plinth or grille.
Ateliers La Cornue· 14 rue du Bois du pont· Z.I Des Béthunes · 95310· Saint Ouen l'Aumône
Installatiegids

Waterpas zetten

by means of a 17
1
9