Preparing The Installation; Transport To Installation Site And Unpacking - La Cornue 599 Serie Notice D'installation

Transport to installation site
2
1
3
The appliance is very heavy.
Take maximum care during handling to
avoid injury.
The appliance should always be transported
in an erect position.
Avoid at all costs leaning it on its front side.
Since this is a large and heavy appliance, before transporting the ap-
pliance, check the access to the location where it will be installed
and unpacking
(door size, manoeuvring space in stairwells, etc.).
The appliance is attached to the base of the packaging (pallet)
through four bolts which can be removed using a 17 mm (0,6 in)
wrench. It is recommended to use a manual transporting device to
move the appliance to the installation site, and only at this point to
remove the base of the packaging.
The appliance should always be transported in an erect position.
If this is not possible, transport the appliance laying on its rear side.
Once at the installation site, the appliance, which is equipped with four
wheels, can be taken off the pallet and positioned in the installation
area.
4
1
Operate as follows:
Take off the four bolts
means of a 17 mm (0.6 in) open spanner.
Remove the fi xing brackets
To remove the front fi xing bracket
the rear wheel adjusting bolt
spanner.
From the back of the unit and by means of a suitable, high duty
hand trolley, take off the appliance and place it on the fl oor.
Be very careful to avoid any damage to fl oors. Delicate fl oors should be
protected with plywood, hard cardboard or similar material panels.
Ateliers La Cornue· 14 rue du Bois du pont· Z.I Des Béthunes · 95310· Saint Ouen l'Aumône
Installation Guide

Preparing the installation

securing the appliance to the pallet by
1
and .
3 4
, unscrew for one or two turns
3
by means of a 13 mm (0.5 in) box
2
7