Electrical And Water Connection - La Cornue 599 Serie Notice D'installation

Electrical and Water connection

Back of appliance
The Built-in fi lter cannot make it safe to drink
any water which is not suitable for human
consumption.
The appliance should be connected only to
a drinkable water supply system.
Do not use extension cords or adapters.
Once the appliance has been connected
to the water system, turn the ice maker off
(touch the button on control panel to
switch it off) before the main water is shut off.
1
2
8
Ateliers La Cornue· 14 rue du Bois du pont· Z.I Des Béthunes · 95310· Saint Ouen l'Aumône
Electrical connection
A Schuko 16 A socket with an effi cient grounding should be made
available for the electrical mains connection, as well as an omnipolar
switch which can easily be reached when the appliance is installed.
To connect to the water supply system (for appliances equipped with
Glaçes) a tap with a male 3/4" connection should be provided, which
must also be easily accessible once the appliance is installed.
The appliance is provided with a water supply hose and seal kit which
is suitable for high water pressure and complies the Food Regulations.
The water fi lter cartridge, which is provided with the appliance, should
be installed according to the accompanying instructions.
Use only the new hose and the new gaskets which are supplied with
the appliance. Discard any hose and gasket which may have already
been installed.
Operate as follows:
Unwind the electric cable and connect it directly to the wall socket.
Make sure the appliance is in the Stand-by condition and that all ights
are off; should it be not so press the Unit button
Connect the water line to the threaded connection at the base of the
unit, as in fi gure
Fit the other end of the hose to the water tap, use the gaskets provided
in the Owner's Kit
Water connection
.
1
.
2
to switch it off.