Built-In Installation Appliances Separated By Wall Or Panel - La Cornue 599 Serie Notice D'installation

Build-in installation appliances
separated by wall or panel
1
2
Wall
or
furniture
6,5 (0,2)
22 (0,8)
A Connecting element
B Aluminium frame
Required accessories to be ordered separately:
Lateral connection kit (KCLMT)
Built-in joining kit (KCIMT)
Anticondensation kit (KAC16)
If the design of the kitchen unit provides for the installation of two ad-
jacent appliances, but separated by an in-between panel (or wall or
cavity) of a thickness below 16 cm (6,2 in), then the installation can
be done as it were two single installations. It is required, however, that
an anticondensation panel is placed on the facing sides of the ap-
pliances. If the in-between panel (or wall or cavity) has a thickness
higher than 16 cm (6,2 in) then this precaution is not required.
Operate as follows:
Position the profi les on the sides of the appliance and, using them as
templates, drill 3 mm (0,1 in) holes onto the sides and fi x the profi les to
the sides by means of the screws provided.
Peel off the adhesive protection from each anticondensation panel
and attach them to the appliance sides facing each other
Push the appliances into the two separate niches
Check the levelling of the appliance, adjusting its feet and wheels
to correct it.
Secure the appliances to the adjacent cabinets and mount the
covering frames as for a single installation (page 12).
Side profi le mounting
C
6 (0,2)
Appliance
6,5 (0,2)
A
B
22 (0,8)
>160 (6,2)
Ateliers La Cornue· 14 rue du Bois du pont· Z.I Des Béthunes · 95310· Saint Ouen l'Aumône
C
6 (0,2)
Appliance
6,5 (0,2)
A
B
22 (0,8)
C Anti-condensation panel
Installation Guide
.
1
.
2
Wall
or
furniture
6,5 (0,2)
22 (0,8)
15