Start Up - La Cornue 599 Serie Notice D'installation

If at the fi rst start up the message Stand-by does
not appear, but other messages appear, such as
Fridge too warm, Fresco too warm, Freezer too
warm, or sound signals are activated, it means, it
means that the appliance has already started the
cooling process.
If this is the case, deactivate any possible acous-
tic signals by pressing the Alarm button, close
the door and wait until the set temperature is
reached.
To start the appliance, connect the plug to the electrical mains: at this
point, when opening the door, the control panel will usually visualize the
message "Stand by", and all the panel keys be off
To turn on all the appliance compartments, press the Unit
for three seconds.
The display will show the message "Initial test" for approx. 2 minutes.
After this phase the compressors will start up and remain on until the
default temperature set up in the factory is reached. Do bear in mind
that this condition could last several hours.
If the appliance is provided with an Glaçe, prior to switch it on make
sure that the water fi lter cartridge is installed, then fi ll the water system.
To this purpose switch off the Glaçe.
Touch the Valider and Glaçe
fi lling which may last a few minutes.
At the end switch the Glaçe on again by touching the
For further information about the appliance operation, refer to the
User Manual.
Ateliers La Cornue· 14 rue du Bois du pont· Z.I Des Béthunes · 95310· Saint Ouen l'Aumône
Installation Guide

Start Up

buttons at the same time, to start the
button.
button
19 19