AL-KO Classic 4.66 P-A Mode D'emploi page 31

T u r n t h e m o t o r o f f
L a w n m o w e r w ith o u t b la d e c o u p lin g
1. S e t th e throttle leve r to position O
2. R e le a s e th e safety b rake han dle
- T h e m oto r is sw itched off.
C a u tio n - d a n g e r o f s e rio u s c u t in ju rie s !
T h e m otor m ay continue running. A fter switching
off, m ake sure th e m otor has stopped turning.
L a w n m o w e r w ith b la d e c o u p lin g
B lade coupling
O n O ff
1. R e le a s e th e safety b rake han dle ( O 25].
2. S e t th e throttle leve r to position O
- T h e m oto r is sw itched off.
C a u tio n - d a n g e r o f s e rio u s c u t in ju rie s !
T h e m otor m ay continue running. A fter switching
off, m ake sure th e m otor has stopped turning.
W h e e l d r iv e ( o p t i o n a l ) ( n 22]
20 /2 ].
(Cl
25].
(Cl
S w itc h in g o n th e w h e e l d riv e
1.
S w itc h in g o ff th e w h e e l d riv e
1
V a r io t r a n s m i s s io n ( S p e e d C o n t r o l ) ( o p t io n a l)
V ario transm ission
2 0 /2 ).
(Cl
F as t
T h e V ario transm ission allow s continuous variation o f the
ground speed of th e law nm ow er.
■
■
B
C a u tio n !
E n g a g e th e transm ission only w hen th e m otor is
running.
P ress th e transm ission control han dle against the
h an d le b ar and hold it ( C l 2 2 ] - th e transm ission
control h an dle does not lock.
- T h e w heel drive is switched on.
R e le a s e th e transm ission c o n tro han dle (°
- T h e w heel drive is switched off.
Slow
C a u tio n !
O p erate th e lever only w hen th e m otor is running.
O perating th e leve r w ithout the m otor drive m ay
d am ag e th e drive m echanism .
To in crease th e speed, pull th e leve r
tow ards ( O 2 3 /2 ]
To lo w er th e speed, pull th e leve r
(Cl 2 3 /1 ]
A lw ays adjust th e ground speed to suit th e current
ground and law n conditions.
G B
2 4 ].
23 ]
(Cl
2 3 ] tow ards
(Cl