AL-KO Classic 4.66 P-A Mode D'emploi page 27

M o w i n g w i t h t h e g r a s s c a t c h e r
^ C a u tio n - R is k o f in ju ry !
A ttach /detach th e grass ca tch e r only w hen th e
m oto r is sw itched off and th e m o w e r b lad e has
co m e to a standstill.
1. Lift th e deflector plate and insert th e grass catcher
in th e holders ( C l 8).
F ill le v e l i n d i c a t o r
T h e fill level indicator is pushed upw ard by th e air flow
w hen m ow ing 7a).
(Cl
If th e grass ca tch e r is full, th e indicator points to th e box
(C l 7b ). T h e grass ca tch e r m ust b e em ptied.
E m p t y in g t h e g r a s s c a t c h e r
1. Lift th e deflector plate.
2. U nhook th e grass ca tch e r and pull backw ard to
rem ove ( a 8).
3. E m pty th e grass catcher.
4. Lift th e deflector plate and insert th e grass catcher
in th e holders (Cl 8).
M o w i n g w i t h o u t t h e g r a s s c a t c h e r
A C a u tio n !
O nly w ork w ithout th e grass catcher if the
deflector plate torsion spring is w orking correctly.
T h e deflector plate is held to th e m o w er housing by
spring force. This ca u ses th e m ow ed grass to be thrown
backw ard and dow nw ard.
M u l c h i n g w i t h t h e m u lc h k i t ( o p t io n a l)
W h en m ulching, th e grass cuttings are not collected, but
are left on th e law n. T h e grass m ulch prevents th e soil
from drying out, and supplies it with nutrients.
T h e b est results are obtained by cutting back regularly
by abo ut 2 cm. O nly young grass with a soft le a f texture
d ecom poses quickly.
■ G rass height before m ulching: 8 cm m axim um
■ G rass height after mulching:
A d ap t your walking pace to the mulching process,
do not walk too fast.
In s e rtin g th e m u lc h kit
C a u tio n - R is k o f in ju ry!
Insert/rem ove the mulch kit only with the m otor
switched off and w hen the m ow er blade has com e
to a standstill.
1. R em o v e th e grass ca tch e r
2. Lift th e deflector plate and insert th e m ulch kit in the
outlet shaft 9).
(Cl
It m ust lock into place.
If the m ulch kit is not locked into position, both the
m ulch kit and the m ow er blade m ay be dam aged.
R e m o v in g th e m u lc h kit
1. Lift th e deflector plate.
2. R e le a s e th e lock on th e m ulch kit ( a 10 /1 ).
3. Pull out th e m ulch kit
G B
4 cm m inim um
8).
(Cl
(Cl 10/2).