ESAB PT-26 Manuel D'instruction page 115

sEctIoN 4
pt-26 steel cutting Data
Plasma Gas: Air @ 60 psig (4.1 bar)
Shield Gas: Air @ 50 psig (3.4 bar)
Start Gas: Air @ 30 psig (2.1 bar)
Stand-Off: 5/16" (7.9 mm)
Material thickness (in)
Plasma Gas: H-35 or Air @ 50 - 60 psig (3.4 - 4.1 bar)
Shield Gas: Air @ 50 psig (3.4 bar)
Start Gas: H-35 Nitrogen or Air @ 30 psig (2.1 bar)
Stand-Off: 5/16" (7.9 mm)
For H-35 Plasma gas, use Nitrogen or H-35 start gas.
Material thickness (in)
115
opEratIoN
50 amps
150 amps
200 amps
300 amps
200 amps
150 amps
200 amps
300 amps
300 amps