Safety Codes And Standards - Electrolux ECFD3068AS Instructions D'installation

30" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
• In the event of an electrical power outage, the sur-
face burners can be lit manually. To light a surface
burner, hold a lit match to the burner head and
slowly turn the Surface Control knob to LITE. Be
careful when lighting surface burners manually.
• Unlike the standard gas range, THIS COOKTOP
IS NOT REMOVABLE. Do not attempt to remove
the cooktop.
WARNING
Do not repair, replace or remove
any part of the appliance unless specifically rec-
ommended in the manuals. Improper installation,
service or maintenance can cause injury or prop-
erty damage. Refer to this manual for guidance. All
other servicing should be done by an authorized
service provider.
• The appliance should only be used if installed by
a qualified technician in accordance with these
installation instructions and all applicable regula-
tions and codes. The manufacturer is not respon-
sible for damages resulting from incorrect
installation.
• Never modify or alter the appliance. For example,
do not remove leveling legs, panels, wire covers
or anti-tip brackets/screws.
• To eliminate the risk of burns or fire by reaching
over hot surface units, cabinet storage space
located above the surface units should be
avoided. If cabinet storage is to be provided, the
risk can be reduced by installing a hood that proj-
ects horizontally a minimum of 5 inches (127 mm)
beyond the bottom of the cabinet. Make sure that
cabinets above the cooktop are a maximum of 13"
(330 mm) deep.
Tip Over Hazard
WARNING
• A child or adult could tip the
• Install the anti-tip device on
• Engage the range with the
• Ensure the anti-tip device is re-engaged when
the range is moved.
• Do not operate the range without the anti-tip
device in place and engaged.
• Failure to follow these instructions can result in
death or serious burns to children and adults.
To check if the anti-tip bracket
is installed properly, use both
arms and grasp the back edge
of the range. Carefully attempt
to tilt the range forward. When
properly installed, the range
should not tilt forward.
Refer to the anti-tip bracket installation instructions
supplied with your range for proper installation.

Safety codes and Standards

This appliance complies with one or more of the fol-
lowing standards:
• UL 858, The Standard for the Safety of Household
Electric Ranges.
• ANSI Z21.1/CSA 1.1 Household Cooking Gas
Appliances.
• CAN/CSA-C22.2 No. 61 Household Cooking
Ranges.
It is the responsibility of the owner and the installer
to determine whether additional requirements and/or
standards apply to specific installations.
Installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or, in Canada, the Nat-
ural Gas and Propane Installation Code, CSA
B149.1. The appliance must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical
Code, NFPA 70 latest edition or, in Canada, the
Canadian Electric Code, CSA C22.1-02.
3
range over and be killed.
the floor or wall as per the
installation instructions.
anti-tip device as per the
installation instructions.