Beko HCA62641BH Manuel D'utilisation page 9

3 Operation of the Appliance
3.5 Replacement of Lamp
(Figure 3)
Make the electrical connections of the appli-
ance. Your appliance uses 3W spot LED lamp.
For replacing the lamps, push downwards
on the holder from its behind, turn it coun-
ter-clockwise, and take it out downwards.
Apply the above operation in reverse to install
new lamps (Figure 3).
Bulb
Bulb Power (W)
Holder / Socket
Bulb Voltage (V)
Size (mm)
ILCOS Code
Cooker Hood / User Manual
3
GZ 10
220 - 240
53 x 50
DR/F3-220-240-
GZ10-50-53
3.6 Operation
Connection
Vapour is extracted through
•
the flue duct, which is fastened
to the connection head on the
hood.
The diameter of the flue
•
duct must be the same as the connection
ring. In horizontal settings, the pipe has to
have a slight upward slope (around 10º) so
that the air can exit the room easily.
3.7 Operation without Flue
Connection
Air is filtered through the
•
carbon filter and recirculated in
the room. Carbon filter is used
when it is impossible to use a
flue in the house.
In flueless use, remove the flaps inside the
•
flue adapter.
Remove the grease filter. To install the car-
•
bon filter, fit the filter to the tabs by centring
it on the plastic piece on both sides of the
fan body. Tighten it by turning right or left.
Replace aluminium grease filter.
•
with Flue
9 / EN