Electrical Connections; Setting The Open Limit Switch - V2 AZIMUT Mode D'emploi

8 - ELECTRICAL CONNECTIONS

The control panel inside AZIMUT is already cabled.
You just need to plug it in the electrical outlet to proceed with
operational parameter programming.
ANT
Antenna
GND Common (-)
IR1
Photocell 1. N.C. contact
IR2 Photocell 2. N.C. contact
IR.V+
+24Vdc supply for photocells
LAMP Flashing light 24V
DOOR START - Open command for
connecting traditional devices with
N.O. contact
GND Common (-)
EMRG STOP. N.C. Contact
9 - SETTING OF THE OPERATION
PARAMETERS
AZIMUT is equipped with a practical interface that allows rapid
and simple on-display programming using four keys:
+ -
, , ,
Preliminary operations:
1. Move the door so as to hook on the drive trolley.
2. Power up the device: the courtesy light comes on, the
control unit emits a BEEP and the segments of the display are
illuminated one at a time until the display shows

9.1 - SETTING THE OPEN LIMIT SWITCH

+
-
Press the key for
5 seconds
+
-
When the door reaches the
desired position, press the
key to save the settings
ANT
GND
IR1
IR2
IR.V+
0
.
+
-
The device emits a beep
I
and the display shows
m
PLEASE NOTE: The open limit switch must be stored prior to
the close limit switch. If this procedure is used erroneously to set
the close limit switch, the parameter is NOT stored
m
PLEASE NOTE: if programming is not completed (by
means of function 9.
End programming) the parameters set are lost.
If there is an error in the set parameters, simply power off
the device, restore power and then repeat the programming
operation.
Press the key:
I
flashes
- 21 -
-
LAMP
+
DOOR
GND
EMRG
+
-
Press and hold the
+
(the door opens)
-
or (the door closes)
key to reach the fully open
position
+
-