Clothing; Use - Texas Hobby 300 Manuel De L'utilisateur

thinner, so it is easier to add to the gear. Avoid cutting off too much of the tip on the
pack. It is important that the tip is as pointed as possible.
Add grease until it comes out of the filler hole when the machine is horizontal.
Operate the clutch lever and pull the starter cord 3 times to distribute the grease
-
around the gear.
Then add more grease until the gear is full.
-
Fit and tighten the screw.
-
Fit the spark plug cover on the engine.
-
Figure 6
Check and top up the gears after every 5 working hours.

Clothing

When working with the tiller, close-fitting work clothes, sturdy
work gloves, hearing protection and boots with non-skid soles
and steel toe caps are compulsory.

Use

Remove all foreign bodies form the area before use. Stone, glass, branches, etc. can
damage the tiller. Check that all bolts on the tiller are tightened.
Starting:
Set the throttle handle to choker/full throttle.
Follow the engine instructions for starting.
Stopping:
Set the throttle handle to minimum throttle.
Follow the engine instructions for stopping.
The tiller is designed for cultivating vegetable gardens and flowerbeds. The machine can
also be equipped with various accessories for a variety of tasks.
Read the instructions carefully and make sure you are familiar with how to start and stop
the engine in particular.
When the clutch cable on the right side of the handle is pressed down, the blades are
activated. It is important that the handle is pressed fully down to the handlebar. This will
ensure optimum tightening of the belt, which transfers the power from the engine to the
transmission.
The ground should generally be tilled 2-3 times in different directions.
Figure 9
Do not cultivate very wet soil, as clods will be formed, and these are difficult to break up
again. Very dry soil may need to be cultivated twice.
Note: The transmission becomes very hot during use.
9