Beurer HS 50 Mode D'emploi page 20

6.2 Straightening/styling hair
1. Dry your hair thoroughly before using the hair straightener. Position
yourself on a dry, non-conductive surface. Make sure that your hands
are dry!
2. Hair should be clean and free from styling products. The exception to
this is special products designed to help straighten hair.
3. Comb your hair with a large-toothed comb to get rid of any tangles.
4. Unlock the hair straightener at the lock mechanism
switch to the position
5. To switch on the hair straightener, press and hold the ON/OFF switch
for three seconds.
4
6. The heat-up phase is shown through three alternating flashing bars in
the LED display
the temperature shown in the LED display
the hair straightener is ready for use.
7. The temperature can be increased by pushing button
ature can be decreased by pushing button
We recommend the following temperature settings:
- 120 °C to 140 °C: Fine, brittle, dyed, bleached hair
- 160 °C to 180 °C: Normal hair
- 200 °C to 220 °C Thick and resistant hair
8. The temperature can be fixed by pressing the
The button lock
ton lock
goes out in the LED display
9. Part the hair into individual sections that are approximately 3 to 4 cm
wide. Hold a section taut and place it between the hot plates
roots.
10. Slowly move the hair straightener from the roots to the tips in a fluid
motion. Do not hold the hair straightener in one place for more than two
seconds. This will achieve the best results without subjecting your hair
to excess stress or damage.
11. You can style the ends of your hair by turning the hair straightener in-
wards or outwards before running it over the tips of the hair.
.
. When the three bars are permanently illuminated,
2
appears in the LED display
11
, press the
5
11
button for 3 seconds. The button lock
.
2
20
by pushing the
6
has been reached and
2
. The temper-
3
.
5
button for 3 seconds.
5
. To cancel the but-
2
11
at the
1