Inserting The Bobbin - Janome S-7330 Manuel D'instructions

z
q
x
c
t
v
t
b
w
e
r
y
22

Inserting the bobbin

1 Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
Thread
q
Bobbin holder
w
2 Guide the thread into the notch on the front of the
bobbin holder.
Notch on the front
e
3 Draw the thread to the left, sliding it between the
tension spring blades.
Spring blades
r
4 Continue to draw the thread lightly until the thread
slips into the notch on the side.
Notch on the side
t
5 Pull out about 10 cm (4") of thread to the rear.
Reattach the hook cover plate.
NOTE:
A threading chart is shown on the hook cover plate for
your reference.
Threading chart
y