Inserting A Bobbin; Inserting The Bobbin Case Into The Hook - Janome HD9 Livret D'instructions

Inserting a Bobbin

z Place a bobbin in the bobbin case making sure the
thread winds clockwise on the bobbin as illustrated.
x Draw the thread through the slit q of the bobbin case.
q Slit
c Continue to draw the thread under the tension
spring w and through the opening e.
The bobbin should spin clockwise when the thread
is pulled out of the bobbin case.
w Tension spring
e Opening

Inserting the Bobbin Case into the Hook

* Be sure that the needle is at its highest position.
z Holding the latch q open, position the bobbin case
into the hook aligning the bulge w with the
concave e.
The bobbin case should lock into place when the
latch is released.
q Latch
w Bulge
e Concave
* Leave the tail of the bobbin thread to the left as
shown.
x Close the hook cover r and attach the hook cover
plate t in this order.
r Hook cover
t Hook cover plate
z
x
c
w
z
x
r
18
q
e
e
w
q
t
2
3
1