Built-In Needle Threader - Janome HD9 Livret D'instructions

Built-in Needle Threader

z Lower the presser foot. Press the Up/Down needle
button twice to raise the needle to its highest
position. Turn the power switch off.
Push down the needle threader knob q as far as it
will go.
x Turn the knob q in the direction of the arrow to
insert the hook into the needle eye.
The hook r comes out through the needle eye
as illustrated.
c Holding the thread with both hands, draw the
thread along the thread path w.
Then hook the thread around the guide e.
v Draw the thread under the hook r.
Hold the end of thread with your hand while pulling
up the thread lightly in the direction of arrow.
b Turn the knob in the direction of the arrow as
shown, drawing the thread loop t through the
needle.
Release the threader knob slowly. Then pull the
thread loop t to the right.
The needle threader may not work
well with these combinations.
Needle Thread
#9 #20, #30, #50, #60
#11 #20, #30
#14 #16, #20, #30
z
x
c
v
b
28
q
w
e
r
t