Bartscher IK 30S-EB Mode D'emploi page 42

GB/UK
Technical Data
Name
Code-no.:
Construction:
Dimensions:
Weight:
Further technical modifications are possible!
Assembly
Device is meant to be installed in a kitchen counter top. During the assembly the
following advice should be taken into consideration:
1. Kitchen top where the cooker will be installed in should be made of heat resistant
materials so that no deformation caused by the device's heat radiation may occur.
2. Make sure that the thickness of the counter top is adequate to the load.
3. Cut out an opening in the counter top as shown in the following drawing. (Fig. 1)
4. Alternatively to the way shown above, the induction cooker can be installed in level
with the surface of the counter top if the surface is made of stainless steel or other
material which is resistant to high temperature. (Fig. 1)
Induction Cooker IK 30S-EB
105936S
Hob: Schott Ceran, Body: plastic
width 290 x depth 510 x height 83 mm
4.5 kg
2.
Fig. 1
- 3 -