Instructions For Use; For Your Safety; Gas Cylinder - Campingaz Plancha Mode D'emploi

INSTRuCTIONS FOR uSE

NOTE: unless otherwise specified, following generic terms "appliance / unit / product / equipment / device" appeared in this
instruction manual all refer to the product "Plancha".
y Please read the instructions carefully before use.
y Use outdoors only.
y It is best to wear gloves to assemble the product.
y Do not use charcoal.
y Do not use an adjustable low pressure regulator. Only use fixed regulators that comply with relevant European
Standards.
y Regularly clean the parts at the frame bottom to avoid risk of inflammation from fat drippings.
Follow these instructions carefully to avoid serious damage to your barbecue.
A. FOR yOuR SAFETy
y Do not store or use petrol and other flammable liquids or
vapours in the vicinity of this appliance. This device must
be kept away from inflammable materials when it is in use.
If you smell gas:
1. Close the valve of the cylinder.
2. Extinguish all naked flames.
3. If the smell continues, see "F. Checking for gas leaks" or
immediately seek advice from your local retailer.
y Do not leave your appliance unattended while it is working.
y Parts which are protected by the manufacturer or the
manufacturer's representative must not be manipulated by
the user.
y Close the gas container after use.
B. LOCATION
y This appliance must be used outdoors.
y CAuTION : accessible parts may get very hot. Keep young
children away.
y There should be no combustible materials within a radius of
approximately 1 meter around the appliance.
y Do not move the appliance when alight.
y Install your appliance and the gas bottle on a flat, level and
non-inflammable surface. If you are using your appliance on
grass, please pay attention that it is not too high and that it
cannot reach the flame to avoid any risks of fire.
y Use the appliance on a stable support and strong enough to
carry the appliance weight (table), flat and horizontal, put the
gas bottle directly on the floor.
y Regardless of the height H, the width or diameter D of the
cylinder, see Fig. 1.
y The gas bottle must be installed at least 30cm away from the
appliance, see Fig. 1.
y Estimated air offtake is 2 m
C. INSTALLATION OF BATTERIES FOR AuTOMATIC
LIGHTING L LIGHTING AND CONSOLE
ILLuMINATION (DEPENDING ON THE MODEL)
ELECTRONIC IGNITION OF GAS BuRNERS :
y The system for automatic lighting of the gas burners is
powered by one AA (LR06) type battery.
y The battery holder is located under the console (Fig. 10).
y See fig. 11 for battery installation:
1) Unscrew the top of the lighting battery holder "A".
2) Insert the AA battery making sure the positive and negative
ends are facing the correct direction as shown (Fig. 11),
then screw the top back in place.
The console illumination system is powered by four AA (LR06)
type batteries. The battery holder is located at the bottom front
area of the appliance (see Fig. 10). Remove the battery holder
/kW/h.
3
lid by sliding it sideways. Insert the batteries making sure the
positive and negative ends are facing the correct direction as
shown, then replace the lid. (see Fig. 12)
You can illuminate each of the control knobs on the control
panel independently.
1. Select a control knob and perform the ignition action (step
#3 in section H), when the burner is lit, control knob will be
illuminated. So you can tell which burner is working.
2. The control knob will remain illuminated until you set it to the
STOP (O) position.
D. GAS CyLINDER
This appliance has been adjusted to operate from 4.5 to 15kg
butane/propane cylinders with an appropriate low pressure
regulator :
■ Switzerland: see separate spreadsheet.
■ France, Belgium, Luxembourg, united kingdom,
Ireland, Portugal, Spain, Italy, Greece:
butane 28-30 mbar / propane 37 mbar.
■ Netherlands, Norway, Sweden, Denmark, Finland,
Czech Republic, Slovenia, Slovakia, Hungary, Romania,
Estonia, Turkey, Bulgaria, Croatia: butane 30 mbar /
propane 30 mbar.
■ Germany, Austria : butane 50 mbar / propane 50 mbar.
■ Poland: propane 37 mbar.
Always connect or replace the cylinder in a well-ventilated
area, never in the presence of a flame, spark or heat source.
Regardless of the height H, the width or diameter D of the
cylinder, see Fig. 1.
E. HOSE
France: The equipment may be used with two types of
flexible hose: (Depending on the model)
a. Flexible hose designed to be joined onto ringed tailpieces on
both the barbecue and regulator sides, held firm with collars
(in accordance with standard XP D 36-110). Recommended
length 1.25 metre. (Fig. 2-A)
b. Flexible hose (according to standard XP D 36-112 or NF
D 36-112) fitted with a G 1/2 threaded nut for fixing to the
barbecue and a M 20x1.5 threaded nut for fixing to the
regulator, recommended length 1.25 metre. (Fig. 2-B)
The barbecue has a G 1/2 threaded gas inlet connector
supplied with pre-fitted NF ringed tailpiece and seal.
1. To use the appliance with the flexible hose XP D 36-110
(Fig. 2-A):
y Slide the flexible hose onto the ringed tailpiece on both
the barbecue and regulator as far as it will go.
y Slide the collars behind the two first bosses on the
tailpieces and tighten them until the tightening head
breaks.
y Check for leaks following the instructions in paragraph P).
9
GB