Troubleshooting - Dometic BORDBAR TB08 Notice D'utilisation

BordBar TB08
9

Troubleshooting

Problem
Your cooler is not
working and the fan
wheel which can be
seen from the outside is
not turning.
The ignition is on and
the cooler is not
working.
Pull the plug out of the
socket immediately and
make the following
inspections.
Your cooler does not
cool satisfactorily and
the outer fan wheel is
not turning.
The cooler does not
cool satisfactorily and
the outer fan wheel is
turning.
EN
Possible cause
No voltage is flowing
from the cigarette
lighter in your vehicle.
The cigarette lighter
socket is dirty. This
results in a poor
electrical contact.
The fuse of the
connection cable has
blown.
The vehicle fuse has
blown.
The fan motor is
defective.
The fan motor for the
inner fan is defective.
The Peltier element is
defective.
The integrated mains
adapter is defective.
Suggested remedy
The ignition must be switched on in most
vehicles to supply current to the cigarette
lighter.
Clean the socket of the cigarette lighter
with a non-metallic brush and a solvent,
to ensure that the middle contact pin is
clean. If the plug of your cooler becomes
very warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
Replace the connection cable fuse (5 A).
Replace the vehicle cigarette lighter fuse
(usually 15 A). Please refer to the
operating manual of your vehicle.
This can only be repaired by an author-
ised repair centre.
This can only be repaired by an author-
ised repair centre.
This can only be repaired by an author-
ised repair centre.
Troubleshooting
13