Safety Of Others - Black & Decker LD12 Mode D'emploi

g. Follow all charging instructions and do
not charge the battery pack or tool
outside the temperature range specified
in the instructions. Charging improperly
or at temperatures outside the specified
range may damage the battery and
increase the risk of fire.
6. Service
a. Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
b. Never service damaged battery packs.
Service of battery packs should only be
performed by the or authorized service
providers.
7. Drill safety warnings
1) Safety instructions for all operations
a. Wear ear protectors when impact
drilling. Exposure to noise can cause
hearing loss.
b. Use the auxiliary handle(s). Loss of
control can cause personal injury.
c. Brace the tool properly before use. This
tool produces a high output torque and
without properly bracing the tool during
operation, loss of control may occur
resulting in personal injury.
d. Hold the power tool by insulated
gripping surfaces, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a
"live" wire may make exposed metal
parts of the power tool "live" and could
give the operator an electric shock.
2) Safety instructions when using long drill
bits
a. Never operate at higher speed than the
maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if
allowed to rotate freely without
contacting the workpiece, resulting in
personal injury.
b. Always start drilling at low speed and
with the bit tip in contact with the
(Original instructions)
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece,
resulting in personal injury.
c. Apply pressure only in direct line with
the bit and do not apply excessive
pressure. Bits can bend causing breakage
or loss of control, resulting in personal
injury.
Additional power tool safety
warnings
Warning! Additional safety warnings for
drill/drivers.
• Use clamps or another practical way to
secure and support the workpiece to a
stable platform Holding the work by hand
or against your body leaves it unstable
and may lead to loss of control.
• Before drilling into walls, floors or ceilings
check for the location of wiring and
pipes.
• Avoid touching the tip of a drill bit just
after drilling, as it may be hot.
• This tool is not intended for use by
persons(including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety. Children should be
supervised to ensure that they do not
play with the appliance.
• The intended use is described in this
instruction manual. The use of any
accessory or attachment or performance
of any operation with this tool other than
those recommended in this instruction
manual may present a risk of personal
injury and/or damage to property.

Safety of others

• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
ENGLISH
ENGLISH
5