Black & Decker LD12 Mode D'emploi page 10

ENGLISH
Drilling in wood
Holes in wood can be made with the same
twist drill bits used for metal or with spade
bits. These bits should be sharp and should
be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in metal
Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass
which should be drilled dry. The cutting
lubricants that work best are sulfurized
cutting oil or lard oil.
Cell indicator
When press the main trigger (1), the cell
capacity indicator turn on at the same to
show the cell capacity status.
10 0 %
0 %
Troubleshooting
Problem Possible cause
Unit will not Battery pack not
start.
installed properl
Battery pack not
charged.
Battery pack not
Battery pack
inserted into charger.
will not charge.
Charger not plugged
in.
10
(Original instructions)
Possible solution
Check battery pack
installation.
Check battery pack
charging requirements.
Insert battery pack
into charger until green
LED appears
Plug charger into
aworking outlet. Refer
to "Important Charging
Notes" formore details.
Unit shuts o
Surrounding air
abruptly.
temperature too hot
or too cold.
Battery pack has
reached its
maximumthermal
limit.
Out of charge.
(To maximize the life
of the battery pack
it is designed to
shut o abruptly
when the charge is
depleted.)
Maintenance
Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Your charger does not require any
maintenance apart from regular cleaning.
Warning! Before performing any
maintenance on the tool, remove the
battery from the tool. Unplug the
charger before cleaning it.
• Regularly clean the ventilation slots in
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this
manual) should be performed by authorized
service centers or other qualified
organizations, always using identical
replacement parts. Unit contains no user
service able parts inside.
Accessories
Recommended accessories for use with your
tool are available at extra cost from your
local dealer or authorized service center.
Move charger and
battery pack to a
surrounding air
temperature of above
40 oF 4,5°C) or below
105 oF (+40,5°C).
Allow battery pack to
cool down.
Place on charger and
allow to charge.