ECOVACS ROBOTICS DEEBOT M82 Manuel D'instructions page 22

5. Troubleshooting
No. Malfunction
DM82 will not clean
4 automatically at
scheduled time.
Remote Control
failure (effective
control range of
5
Remote Control is
20
EN
Possible Cause
Time Scheduling function is
cancelled.
DM82 is powered OFF.
The robot's battery is low.
DM82's components are
tangled with debris.
The batteries in the
Remote Control need to be
replaced.
DM82 is powered OFF or
DM82's battery is low.
The infrared signal cannot
be transmitted because
the Infrared Emitter on the
Remote Control or DM82's
Infrared Receiver on DM82
is dirty.
There is other equipment
interfering with the infrared
signal to DM82.
Solutions
Set Time Scheduling function as
described in section 3.4.
Power ON DM82.
Keep DM82 powered ON and on the
Charging Dock to make sure it has a
full battery to work at any time.
Power OFF DM82, clean the Dust
Bin, and invert the robot. Clean Side
Brushes and the Main Brush as
described in section 4.
Replace with new batteries making
sure they are installed correctly.
Make sure DM82 is powered ON
and fully charged.
Use a dry cloth or the brush side of
the provided Cleaning Tool to wipe
the Infrared Emitter on Remote
Control and the Infrared Receiver on
DM82.
Avoid using the Remote Control
near other equipment using infrared
signals.