Attaching The Auxiliary Handle; Height Adjustment - Black & Decker LST220 Mode D'emploi

ATTACHINg THE AUxILIARY HANDLE

• To attach the handle,
press in on the buttons (f)
on both sides of the upper
housing as shown in figure
5.
• Position the handle as
shown in figure 6 (with
the BLACK+DECKER logo
facing upward). Partially
push the handle on so that
it will hold the buttons in
when you release them with
your hand.
5
f
6
• Push the handle
completely onto the housing
and position it slightly until it
"snaps" into place (figure 7).
• To adjust the handle up or
down, press in on the button
(g) and raise or lower the
handle.
• The handle should be
adjusted so that your front
arm is straight when the
trimmer is in the working
position.

HEIgHT ADJUSTMENT

• The overall height of the
trimmer can be adjusted by
loosening the collar (h) and
rotating it in the direction of
the arrow shown in figure 8.
• Move the upper housing
straight up or down. When
the desired height is
achieved, tighten the collar
(h) by rotating it opposite of
the direction shown in
figure 8.
8
7
8
h
g