Protecting The Environment - Black & Decker GTC18452PC Mode D'emploi

The cutting blades are made from high quality, hardened steel
and with normal usage, they will not require resharpening.
However, if you accidentally hit a wire fence, stones, glass or
other hard objects, you may put a nick in the blade. There is
no need to remove this nick as long as it does not interfere
with the movement of the blade.
If it does interfere, remove the battery and use a fine toothed
file or sharpening stone to remove the nick. If you drop the
trimmer, carefully inspect it for damage. If the blade is bent,
housing cracked, or handles broken or if you see any other
condition that may affect the trimmer's operation contact your
local BLACK+DECKER Service Center for repairs before
putting it back into use. Fertilizers and other garden chemicals
contain agents which greatly accelerate the corrosion of
metals. Do not store the unit on or adjacent to fertilizers or
chemicals. With the battery removed, use only mild soap and
a damp cloth to clean the unit. Never let any liquid get inside
the unit; never immerse any part of the unit into a liquid. Pre-
vent the blades from rusting by applying a film of light machine
oil after cleaning.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the new
u
plug.
Connect the blue lead to the neutral terminal.
u
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 5 A.
(Original instructions)
Troubleshooting
Problem Possible Cause
Slow running, noisy Dry, corroded blades.
or hot blades.
Blade or blade support
bent.
Bent or damaged teeth.
Loose blade bolts.
Unit will not start. Battery not installed
properly.
Battery not charged.
Lock off not fully
operated.
Battery won't Battery not inserted into
charge charger.
Charger not plugged in.
Surrounding air
temperature too hot or
too cold.

Protecting the environment

Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries accord-
ing to local provisions. Further information is available at
www.2helpU.com
ENGLISH
Possible Solution
Lubricate blades.
Straighten blade or blade
support.
Straighten teeth.
Tighten blade bolts.
Check battery installation.
Check battery charging
requirements.
Check lock off is fully
depressed prior to moving
main trigger.
Insert battery into charger
until green LED appears.
Charge up to 8 hours if
battery totally drained.
Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details. Check current at
receptacle by plugging in
a lamp or other appliance.
Check to see if receptacle
is connected to a light
switch which turns
power off when you turn out
the light.
Move charger and tool to a
surrounding air temperature
of above 40 degree F
(4.5°C) or below 105
degree F (+40.5°C).
9