When To Change The Exhaust Filter; How To Replace The Air Clean Filter - Miele HS14 Mode D'emploi

When to change the exhaust filter

Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters
(dia. 11):
a Air Clean
Replace this filter every time you start a
new packet of Miele dustbags. An Air
Clean exhaust filter is supplied with
every packet of Miele dustbags.
b ActiveAirClean 50 (black)
c HEPA AirClean 50 (white)
Replace if the display for the exhaust
filter change indicator is completely
filled with red (dia. 16).
This occurs after approx. 50 operating
hours, or approx. one year of average
use. The vacuum cleaner can still be
used with the exhaust filter indicator lit
up. However, the suction power will be
reduced as will the effectiveness of the
filter if it is not replaced in good time.

How to replace the Air Clean filter

(dia. 32 + 33)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Press the release catch on the filter
grille and open the grille until it clicks.
^ Hold the used Air Clean filter by one
of the clean, unsoiled sections.
^ Replace it with a new Air Clean filter.
All manuals and user guides at all-guides.com
^ Close the filter grille.
^ Close the dust compartment lid
How to replace an ActiveAirClean 50
filter or a HEPA AirClean 50 filter
(dia. 34 + 35)
^ Open the dust compartment lid.
^ Lift the filter and remove it.
^ Replace with a new filter, and push it
^ Press the reset button ~ for the
^ After approx. 10 - 15 seconds a thin
^ Close the dust compartment lid
If you wish to replace the Air Clean
filter with an ActiveAirClean 50 filter
or with an HEPA AirClean 50 filter,
see "Replacing one type of exhaust
filter with another".
securely, making sure it clicks into
position.
Do not use more than one exhaust
filter at a time.
down into place.
exhaust filter change indicator
(dia. 14).
red stripe will appear in the left hand
side of the display (dia. 15).
If you wish to use an Air Clean filter,
see "Replacing one type of exhaust
filter with another".
securely, making sure it clicks into
position.
en
41