IKEA ADRATT 904.620.39 Mode D'emploi page 41

EN
Problem
Flames inside oven or
smoking from oven vent.
Oven smokes excessively
when broiling.
Oven light does not work.
Fan noise occurring after
the oven is turned off
Self clean does not work.
Oven racks discolored or do
not slide easily.
Soil not completely removed
after self clean.
More Problems
Cause / Solution
Excessive spills in oven. Grease or food spilled onto the oven bottom or oven
cavity. Wipe up excessive spills before starting the oven. If fl ames or exces-
sive smoke are present when using broil, see "Setting Broil" on page 20
Incorrect setting. Follow the "Setting Broil" on page 20.
Meat too close to the broil element or burner. Reposition the broil pan to pro-
vide proper clearance between the meat and broil element or burner. Remove
excess fat from meat. Cut remaining fatty edges to prevent curling, but do
not cut into lean.
Grease build up on oven surfaces. Regular cleaning is necessary when broil-
ing frequently.
Grease or food splatters will cause excessive smoking.
Other Problems
Be sure the oven light is secure in the socket. See "Replacing the Oven Light"
on page 37
Some models are equipped with a cooling fan that runs during the cooking
process to cool internal electronic components. It is normal for this fan to
continue to run for an extended period of time, even when the oven has been
turned off.
Self Clean problems
Oven control not set properly. See "Setting Self Clean" on page 30.
Oven racks left in oven cavity during self clean. Remove oven racks from oven cav-
ity before starting a self-clean cycle. Clean by using a mild abrasive cleaner following
manufacturer's instructions. Rinse with clean water, dry, and replace in oven.
Self clean was interrupted. Review instructions on "Setting Self Clean" on page 30.
Excessive spills on oven bottom. Remove excessive spills before starting self clean.
Failure to clean soil from the oven frame, the door liner outside the oven door gasket,
and the small area at the front center of the oven bottom. These areas are not in the
self-cleaning area, but get hot enough to burn on residue. Clean these areas before
starting the self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon
brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
BEFORE YOU CALL
41