IKEA ADRATT 904.620.39 Mode D'emploi page 12

BEFORE SETTING OVEN CONTROLS
Removing and Replacing the Glide
Racks
The fully extendable Glide rack makes food prepara-
tion easier. This oven rack has glide tracks that al-
low the rack to be pulled away from the oven with-
out rubbing the sides of the oven wall.
To remove - Make sure the baking rack is in the
closed position. Using one hand, reach through
handle opening and grasp both the upper and lower
portions of the glide rack as shown here.
Figure 3: Grasp both rack sections
While holding both sections, pull the glide rack out
of the oven until the stop position is reached.
Figure 4: Pull rack to stop position
Using both hands, lift up the front of the rack
slightly and continue to pull the rack away from
the oven (Figure 5). Be sure to grasp both upper
and lower rack portions together when removing or
handling the glide rack
Figure 5: Remove and replace using both
hands
12
The rack portions move independently and can be
diffi cult to handle unless held together.
To replace - Make sure the baking rack is in the
closed position. Grasp both upper and lower por-
tions of glide rack. Lift and hold the rack level
between the oven cavity walls. Tilt the front of the
rack upward slightly and slide the rack completely
into position.
To prevent possible damage to the oven, do not
attempt to close the oven door until all the oven
racks are fully positioned back inside the oven
cavity.
IMPORTANT
Do not line the oven walls, racks, bottom or any
other parts of the oven with aluminum foil or with
any other materials or oven liners. Doing so will
alter heat distribution and may cause permanent
damage to the oven interior. During clean the oven
temperatures will be hot enough to melt foil.Most
oven doors contain glass that can break. Do not
close the oven door until all the oven racks are po-
sitioned correctly in the cavity. Do not hit the glass
with bakeware or any other objects. Scratching,
hitting, jarring, or stressing the glass may weaken
its structure, causing an increased risk of breakage
at a later time.
CAUTION
Remove all oven racks before starting a self clean
cycle. If oven racks are left inside the oven during
a cleaning cycle, the slide ability of the oven racks
may be damaged and all of the oven racks will
lose their shiny fi nish.
To prevent possible damage to the oven, do not
attempt to close the oven door until all the oven
racks are fully positioned back inside the oven
cavity.
EN