Bosch PSR Select Notice Originale page 30

OBJ_BUCH-1564-002.book Page 30 Wednesday, July 10, 2013 3:28 PM
30 | English
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
24.11.2011
Assembly
 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational direc-
tion switch to the centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
Battery Charging (see figure A)
 Do not use other battery chargers. The supplied battery charger is de-
signed for the Lithium-Ion battery in your machine.
 Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Bat-
tery chargers marked with 230 V can also be operated with 220 V.
Note: The battery is supplied partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before using
your power tool for the first time.
The lithium ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The Lithium-Ion battery is protected against deep discharging by the "Electron-
ic Cell Protection (ECP)". When the battery is empty, the machine is switched
off by means of a protective circuit: The inserted tool no longer rotates.
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows charg-
ing only within a temperature range of between 0 °C and 45 °C. A long bat-
tery service life is achieved in this manner.
1 609 92A 0AG | (10.7.13) Bosch Power Tools