Nolan N43 AIR Sécurité Et Instructions D'utilisation page 17

VPS ASSEMBLY INSTRUCTIONS
To assemble the VPS, open or disassemble the helmet visor and make sure the side
slider is in upward position (Fig. 7B).
Insert the VPS left end into the left side guide until the grip pawl is hooked in shell
housing.
Repeat the same steps on the right side (Fig. 9).
Press the VPS slightly inwards near its upper grip pawl. At the same time press the
VPS in the seat obtained between the outer and inner shells (Fig. 8).
Push the VPS upwards, making sure that the side slider is moving upwards (Fig. 7B).
Check the correct VPS operation by moving the left side slider downwards (Fig.
7A) and upwards (Fig. 7B) until you hear the clicks meaning that it is in the rele-
vant positions.
If necessary, repeat the above-mentioned steps.
- If the visor and/or VPS opening/closing mechanisms are damaged or malfunc-
tioning, please contact a Nolan authorised dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING
- The VPS doesn't replace the protection guaranteed by the visor.
• REMOVABLE INNER COMFORT PADDING
1 DISASSEMBLY
1 Open the chin strap (see specific instructions), remove the roll-neck flap from the
cheek pad (Fig. 10), pull the front part of the left cheek pad towards the inside of
the helmet and pull out the left fastening chin strap from the slot on the cheek pad
(Fig. 11). Repeat the same operation on the right side of the helmet.
2 Release the roll-neck eyelet from the frame fixed to the outer shell (Fig. 12).
3 Release the left rear fastening flap from the support fixed to the inner shell by
slightly deforming the shell sealing edge and slightly pulling the comfort padding
in the helmet neck-ring area towards the inside (Fig. 13).
Then repeat the same steps to remove the central flap as well as the right rear
flap.
4 Hold the left front part of the liner and pull it upwards in order to remove the liner
flap from the support fixed to the inner polystyrene shell (Fig. 14). Repeat the
same steps to remove the central and right front flap.
5 Completely remove the liner from the helmet.
2 ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base.
2.2 Insert the left front flap into the seat on the support fixed to the polystyrene inner
shell and push it slightly downwards until it is completely locked (Fig. 14). Follow
the same steps for the central and right front flap.
17