Nolan N43 AIR Sécurité Et Instructions D'utilisation page 15

WARNING: every time you wish release the chin guard to use your helmet in the
JET version, insert the right and left CHIN GUARD COVERS in the louvers on the
right and left side frames and push them towards the inside of the helmet until
you hear a fastening click(Fig. 5).
Note: The CHIN GUARD COVERS are all different among them and they are
marked on their back as R (Right) and L (Left).
2 CHIN GUARD FASTENING
1 Open the visor completely.
Before fastening the chin guard to the helmet, perform the operations as
described below to remove the CHIN GUARD COVERS:
2 Pull the right release lever upwards and at the same time remove the right side
protection, by pulling it towards the outside (Fig. 5). Perform the same operation
also on the left side of the helmet.
3 Insert the right end of the chin guard into the right side frame louver of the hel-
met, and press it towards the inside of the helmet until you hear the fastening
click (Fig. 6). Perform the same operation on the left side of the helmet.
4 Make sure the chin guard is correctly fastened at both ends by gently pulling it
towards the outside of the helmet.
WARNING!
- Never remove the semi-rigid inner padding of the chin guard.
- When the helmet is used without chin guard, always assemble the chin
guard covers supplied.
- If in doubt on how the manual chin guard release device works, please con-
tact a Nolan dealer.
• VISION PROTECTION SYSTEM (VPS)
The new and exclusive inner Vision Protection System (VPS) is a scratch-resistant
coated, moulded,
or up to respectively activate it or remove it from the field of vision. It is useful in all
sorts of situations, both on long journeys out of town and shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
VPS operation
The VPS mechanism allows you to activate the sunscreen by simply lowering it until
it partially covers the visor field of vision. In this way, the desired light transmittance
reduction is achieved. At any time, independent of the visor, the VPS can be deacti-
vated with a simple movement and easily pulled up to restore the normal conditions
of visibility and protection guaranteed by the approved helmet visor.
To deactivate the VPS, push the slider towards the bottom of the helmet (Fig. 7A) until
® sunscreen. Its use is simple and practical: Just pull it down
15