Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 4: Unscrewing 2pcs Standard Screws and Washers (BB) as arrow showed from Support Bar – UPPER (E).
Attach Flame Screen (B) to the top of Whole Support Bar and fix by using 2pcs standard screws and washers.
Repeat this step to connect Flame Screen (B) with left 3sets Whole Support Bar.
STEP 6: Unscrews 8pcs Standard Screws and Washers (BB) from top of tank housing assembly (K).
Lift the assembled upper parts of heater and place them on the tank housing.
Push support bar as photo showed and make sure each support bar inserts into slot.
Fix at bottom position by using 8pcs standard screws and washers (BB).
STEP 5: Place Reflector (A) on the Flame Screen (B) and
fix by using 4pcs M5 CAP NUT (AA).
EN
7
Publicité
Table des Matières
