Hendi 272404 Mode D'emploi page 10

OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE
PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL KNOB ANTI-CLOCKWISE TO THE
PILOT SETTING. PRESS KNOB IN AND HOLD FOR 3 MINUTES BEFORE ATTEMPTING IGNITION.
BATTERY REPLACMENT
Remove impulse ignition cap from Burner Assembly (J) by turning cap counterclockwise. Install 1 AAA battery.
Negative end of battery goes in first, then replace impulse ignition cap by turning cap clockwise.
TO LIGHT THE PILOT
Check all connections prior to each use.
!
Turn on main gas supply at source.
!
Press to turn control knob anti-clockwise to PILOT,
!
see right photo.
Hold knob depressed, press IGNITION button
!
repeatedly until pilot flame is lit, then continue to
hold the knob depressed for 10 seconds until the
pilot remains it after releasing knob.
If pilot fails to ignite or alight, press to turn knob
!
clockwise to OFF and repeat.
TO LIGHT THE PATIO HEATER
The pilot should be lit and the knob set to PILOT.
!
Hold knob depressed gently and turn anti-clockwise to LOW.
!
EN
When mesh glows lit, turn knob clockwise from Low to HIGH as needed.
!
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn
the control knob to the pilot position. Then turn the knob to the level of heat desired.
RE-LIGHTING
Turn Control Knob to OFF.
!
Wait at least 5 minutes, to let gas dissipate, before attempting to re-light pilot.
!
Repeat the "Lighting" steps.
!
TO EXTINGUISH
Hold knob depressed & turn the knob clockwise to 'OFF'
!
Close the valve of the gas cylinder or the regulator after use.
!
Close the gas bottle and allow this appliance to cool before moving the appliance.
!
Note: After use, some discoloration of the emitter screen is normal. Close regulator after use, allow the
appliance to cool before moving.
10