Connection Example; Connecting 15K Rgb/Component Equipment - Sony VPL-V500Q Mode D'emploi

Connection Example

For details on how to conncet a computer, a VCR or
external active speakers, see page 14. Also refer to the
instruction manual of the equipment to be connected.
When making connections, be sure to:
• Before connecting any cables, make sure that each
piece of equipment to be connected is turned off.
• Use cables appropriate for the equipment to be
connected.
• A loose connection may cause hum or noise.
• When disconnecting a cable, pull it out from the plug;
not the cable itself.

Connecting 15k RGB/Component Equipment

15k RGB/component equipment
to a wall outlet to AC IN
AC power cord
(supplied)
Notes
• This unit cannot accept separate sync signal with 15k
RGB/component input signal. Use composite sync
(negative) or Sync on Green.
• When inputting a frequency of VGA or an equivalent
from an equipment such as scan-converter, use
separate sync signal.
30
(EN)
Front
S VIDEO VIDEO
L (MONO)
VIDEO IN AUDIO IN
Connecting a BNC connector:
2 Twist to the right.
to RGB/component output
SMF-400 conversion cable (not supplied)
5X BNC ˜ HD D-sub 15-pin (male)
INPUT A
R
75Ω
ON
OFF
AUDIO IN
Set the 75-ohm termination
switch to ON.
• This unit cannot accept a interlace signal of VGA or
an equivalent other than 15k RGB/component signal.
• Select the RGB or COMPONENT signal with the
INPUT-A item on the SET SETTING menu.
1 Align the pins with the pin holes and
push in the plug into the socket.
L R
AUDIO OUT
CONTROL S IN