The Input Setting Menu - Sony VPL-V500Q Mode D'emploi

The INPUT SETTING Menu

The INPUT SETTING menu is used to adjust the input
signal. Items which can be adjusted are displayed in
green.
D O T P H A S E : 4 8
INPUT
S I Z E H : 8 0 0
SELECT
S H I F T H : 1 2 3 V : 1 2 3
PICTURE
F I L T E R : O F F
CTRL
C L A M P : A U T O
INPUT
C O L O R T E M P : H B M
SETTING
SET
S A V E T O M E M O R Y
SETTING
INPUT
INFO.
For details on initial setting signals, see page 38.
Operation
1. Select an item
Use the V or v key on the control panel to select the
item, then press the b or the ENTER key.
On the Remote Commander, move the joy stick up or
down to select the item, then move it to the right or
press the ENTER key.
2. Adjust an item
• When changing the adjustment level:
To increase the number, press the V or the b key.
On the Remote Commander, move the joy stick up
or to the right.
To decrease the number, press the v or the B key.
On the Remote Commander, move the joy stick
down or to the left.
Press the ENTER key to restore the original screen.
• When changing the setting:
Press the V or the v key to change the setting.
On the Remote Commander, move the joy stick up
or down to change the setting.
To restore the original screen, press the ENTER or
the B key.
On the Remote Commander, move the joy stick to
the left.
.........................................................................................................................................................................................................
22
1) VESA is a registered trademark of Video Electronics Standard Association.
(EN)
I N P U T - A
SEL: EXIT: MENU
DOT PHASE
Adjusts the dot phase of the LCD panel and the signal
input from INPUT A.
D O T P H A S E : 4 8
SIZE
Adjusts the horizontal size of pictures input from
INPUT A.
S I Z E H : 8 0 0
The higher the setting, the larger the horizontal size of
the picture.
The lower the setting, the smaller the horizontal size of
the picture. Adjust the setting according to the
horizontal dots of the input signal.
Input signal
VGA
Macintosh13-inch mode
15k RGB
1)
VESA 72 Hz (640×480 dots) 832
S VGA VESA 56 Hz
S VGA VESA 60 Hz
SHIFT
Adjusts the position of the picture input from INPUT
A.
S H I F T H : 1 2 3 V : 1 2 3
H adjusts the horizontal position of the picture.
V adjusts the vertical position of the picture.
As the setting for H increases, the picture moves to the
right, and as the setting decreases, the picture moves to
the left.
As the setting for V increases, the picture moves up,
and as the setting decreases, the picture moves down.
Use the B or the b key to adjust the horizontal position
and the V and v key for the vertical position.
Setting
800
864
800
819
844