Sony VPL-V500Q Mode D'emploi page 17

To turn off the power
4
Press the PATTERN key on the control panel to display the "H" test
pattern, and turn the focus ring to adjust the focus.
H H H H H H H H
H H H H H H H H
H H H H
H H H H
H H H H H H H H
H H H H H H H H
Press the PATTERN key again to clear the pattern.
5
Turn the zoom ring to adjust the size of the picture.
6
Turn the focus ring again to adjust the focus.
Note
Do not look into the lens when the projector lamp is on.
To
Adjust the volume
Cut off the sound
Cut off the picture
1
Press and hold the POWER key on the control panel or the Remote
Commander for about one second.
The POWER indicator flashes in green and the fan continues to run for
about 10 minutes to reduce the internal heat. The POWER indicator
flashes quickly for the first minute. During this time, you will not be
able to turn the power back on with the POWER key. After about one
minute, you can turn on the power with the POWER key.
2
Wait until the fan stops running and the STANDBY indicator lights in
red; then press the MAIN POWER switch to turn off the main power
(o OFF).
Notes
• Do not press the MAIN POWER switch while the fan is still
running; the fan will stop while the lamp is still hot, leading to
breakdown.
• To make the lamp life last longer, do not turn off the power at
least for about 10 minutes after turning on the power.
Press
the VOLUME +/– keys.
the AUDIO MUTING key. To restore
the sound, press the AUDIO MUTING
key again or press the VOLUME + key.
the PICTURE MUTING key (PIC
MUTING key on the Remote
Commander). To restore the picture,
press the PICTURE MUTING key
again.
17
(EN)