Functions; Operation; Before Use; Connecting The Device - AEG 97015 Mode D'emploi

28 www.aeg-automotive.com

Functions

The charger is equipped with a microprocessor
(McU - Micro computer Unit) and features fully
automatic charging-, diagnostic-, emergency- and
maintenance functions. After selecting the battery
type connected (6 V or 12 V) the battery charger
will recognise the battery capacity and the battery
condition and calculate the required charging pa-
rameters (charging voltage, charging current). This
allows for efficient and safe charging. If the wrong
battery voltage is set or the battery is defective, it
will not charge and the "Error" LED (9) will light up
(also see "Troubleshooting").
The "trickle charge" function allows the charger
to be permanently connected. A full charge will be
maintained.

OPERATION

Before use

Warning!
Before using this device be sure to read the ope-
rating manual for the battery and the vehicle and
understand all safety notices.
•
Use safety goggles and acid-proof safety gloves.
•
Ensure adequate ventilation.
•
Ensure the battery poles are clean. If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.
•
If the battery does not have caps, refer to the
manufacturer instructions on charging and the
charging speed.

Connecting the device

1. Connect the required
terminal connection
cable (with rings or
clamps) to the device's
comfort plug connection
(3).
2. Connect the red (+)
pole connector cable to
the positive pole of the
battery.
3. Connect the black (-)
pole connector cable to
the negative pole of the
battery.
Note:
The black (-) clamp can also
be connected to the vehicle chassis (Please refer to
the auto maker's instructions!). Be sure both clamps
have good contact and are securely seated.
Warning!
Risk of fire and electric shock! If possible, connect
the charger to the 230 V power socket without
extension cable. In exceptions, use the shortest
possible undamaged and unrolled 230 V extension
cable.
4. Plug the charger plug into a 230V power socke.
If the charger is connected correctly, the "Power"
LED (12) will light up. In this mode the charger will
automatically reset to the default settings.
If the battery is recognised to be defective or
connected with the poles reversed, the "Error" LED
(9) will light up. In this case, unplug the charger and
check the battery and the correct connection (also
see "Troubleshooting").
6 V 12 V
V
3,5 A 7 A
V A %
V/A/%
7 A